I will discuss some basic issues that are often found by the motorcycle rider and want to try to find these problems with the motorcycle.
- Motorcycle difficult or does not want to start
- Motorcycle start but not stationer
- Motorcycle feels clogged
- Detection motorcycle roll
- Motorcycle wasteful fuel
- Braking system
- Symptoms of clutch slip
There are three things requirements for the motorcycle to be perfect start.
- Sparks plug it
- Flow fuel smoothly
- Compression enough
So when you find it difficult to motorcycle is turned on, find it with conducting the above three points sequentially. This is important to simplify and speed up the search.
Check the fire.
Checks carried out a fire started from the back to plug bobbin fire engine on the left side of the motor.
First open end of the plug and paste elektoda plug on the chassis body when the plug head is inserted, and then start. If it seem good fire plug, checks on the fuel flow and engine compression. But, if the fire is weak, open plug head of the coil cable. Continue with paste it to chassis body, and start. If the fire is good, the problem exists on the spark plugs or spark plugs in the head. Clean or replace the part and check back sprinkling fire. But when coil cable no fire, do the checks on the cable from CDI to coil. Paste in the chassis body then start ago. If there is a fire sprinkling, coil means weak or broken. Try another coil and check again to ensure that your motor coil really damaged. Conversely, when there is no spark of fire in the CDI cable, do check on the cable from bobbin to CDI. Cable are usually black and red strip. Paste in the chassis body, and start. If there is only a small spark of fire is quite problematic shows that the CDI. But if there is no fire, then sprinkle bobbin must be replaced or repaired. Atau bisa juga ada masalah pada magnet sepul. Or can also have problems in the magnet of bobbin.
Checking the flow of fuel.
Turn off the contact. Kick start engine a few times and open the plug. Is the spark plugs wet? It mean if the fuel flow. But if the spark plugs dry, continue checking on the manifold, hose and tap the fuel. Open the fuel hose to the carburettor. Whether the fuel flowing smoothly. If you use the tap, tap to open a position on. If using a vacuum type of tap, Start and see the bursts of motor gasoline. If clogged or does not appear to shoot out the possibilities :
- Fuel hose is leak
- Broken fuel tap or clog
- The tank was dirty
- Or no fuel in the tank.
Also check the carburettor manifold. Are there leaks at the gasket? or have cracked the manifold itself?. It also possible manifold and carburettor does not stick to the surface perfectly. This could occur because one of the surface have changed by heat engine. When a change is not too severe forms can still trim back with use amrill or sandpaper. Put amrill or sandpaper on a flat surface such as glass or ceramic tile. Then scrub the surface uneven. Pressure balanced and do gradually.
Checking engine compression.
If the plug wet, do check the engine compression. Open the plug. Press and plug holes with the fingers, kick engine start for several time. Feel the compression at your finger. Is it weak, strong or capricious. Jika hentakan kuat dan tidak berubah-ubah, bisa dipastikan kompresi baik. If the compression is strong and does not change, can be compression is well. But if it weak or change, make check valve and piston. For the one that you should contact the workshop.
Tidak ada komentar:
Posting Komentar